Add and monitor snmp device in applicare dashboard

Community · Community Help

Community post

Shared by the Applicare community. It has not been re-checked against Applicare 10.0, so confirm the steps in your environment or contact Support.

1. In the Overview screen click the "Add server" button.

[Screenshot 1 is not available on this page.]

2. In the Add server popup do the below steps.

Enable "IS SNMP Agnet" option.
Enter the Device name.
Enter the Host name. Which we have configured in the Inbound Rules. (Refer Point 24)
Select "Standard" option in the MIB Organization.
Click "Apply" to save the settings.

[Screenshot 2 is not available on this page.]

3. Configure a new Dashboard with Sensor analyzer.

[Screenshot 3 is not available on this page.]

[Screenshot 4 is not available on this page.]

[Screenshot 5 is not available on this page.]

4. Adding Sensors as a Custom Dashboard.

Adding UDPLocalPort connections

[Screenshot 6 is not available on this page.]

[Screenshot 7 is not available on this page.]

Adding TCPLocalPort connections

[Screenshot 8 is not available on this page.]

[Screenshot 9 is not available on this page.]

4. Monitoring Sensors Dashboard

[Screenshot 10 is not available on this page.]

[Screenshot 11 is not available on this page.]

Join the discussion

Comments, voting and following are kept by Zendesk and need a Help Center account. This button opens the original discussion there.

Opens Zendesk · needs internet and sign-in