Run the Applicare Controller as a service on Linux

Updated Aug 22, 2024 controller linux Applies to 10.0, 9.2 Not yet checked for Applicare 10.0

Check this against your version

This article was last updated on Aug 22, 2024, before Applicare 10.0 was released (Jun 19, 2026), and has not been re-checked for Applicare 10.0. Confirm the steps in your environment or contact Support.

To install or uninstall applicare.service, admin permissions are required.

1. Navigate to the directory where the Applicare Controller is installed.

2. Run ./installControllerService.sh to install applicare.service. This command will both install and start the service.

Screenshot 1 — Run the Applicare Controller as a service on Linux

1. To view service status execute the command systemctl status applicare

Screenshot 2 — Run the Applicare Controller as a service on Linux

2. To Stop service execute the command systemctl stop applicare

Screenshot 3 — Run the Applicare Controller as a service on Linux

3. To Start service execute the command systemctl start applicare

Screenshot 4 — Run the Applicare Controller as a service on Linux

4. To Uninstall service execute ./uninstallControllerService.sh

Screenshot 5 — Run the Applicare Controller as a service on Linux

Was this article helpful?

Votes and follows are kept by Zendesk, so they need a Help Center account. These buttons open this article there.

Vote on this article Follow for updates

Opens Zendesk · needs internet and sign-in

Run the Applicare Controller as a service on Linux

Was this article helpful?

Articles in this section: Install, start & update

Related articles