Auto KBT configuration using JMeter

Auto KBT configuration using JMeter

Click below link to download ReadMe document:

https://www.dropbox.com/s/kb199dqqj6g44s0/Auto%20KBT%20configuration%20using%20JMeter.docx?dl=0

Following steps are used to create auto KBT config using jmeter:

1. Download jmeter from https://jmeter.apache.org/download_jmeter.cgi
2. Right click on Test Plan and add Thread Group.

Test Plan -> add -> Threads (Users) -> Thread Group

3. Both users and loop count should be 1 to create KBT configuration at once.> [Screenshot 1 is not available on this page.]
4. Right click on Thread Group and HTTP Request

Thread Group -> add -> Sampler -> HTTP Request

5. Enter protocol, IP address, port number, path like below to which URL you want to add as KBT.

And you should add the parameter ‘autoKBTName’ and value as what name you want to set as KBT name. (Note: Name should be <= 20 characters)> [Screenshot 2 is not available on this page.]

6. Right click on Thread Group and View Results Tree

Thread Group -> add -> Listener -> View Results Tree

[Screenshot 3 is not available on this page.]

7. Click Run -> Start to run jmeter.

Before run jmeter: number of key business transactions = 1

[Screenshot 4 is not available on this page.]

After ran jmeter: number of key business transactions = 2

[Screenshot 5 is not available on this page.]

8. Once KBT is created, you can do load run by setting up users count and loop count.> [Screenshot 6 is not available on this page.]
9. End